Optional accessories include the HD Series Roderick, T-Nut kits for organized internal storage, Caroline, Pickup Vault two-drawer bed storage systems and interior lighting and carpeting Aluminum Paneled Indoor The Outdoors man Indoor (vented) Indoor (Solid Glass) Screen Vent Aluminum Paneled Rear Door Single T-Lock Heavy-Duty Rear Door Double T-Lock Heavy-Duty Rear Door Full Fiberglass Walk-in Door Sliding Front Window Compression Front Boot Fabric Headliner LED Lighting Prime Design Roof Racks A.R.E.
Each product comes with easy to understand vehicle specific installation instructions. HD Series, that the body will be structurally free from defects in material and workmanship for as long as you own your cap and the original vehicle.
The body includes the fiberglass shell and mounting rails only. Warrants to you, the original purchaser, for as long as you own your cap that the exterior paint will not abnormally fade or peel due to material or workmanship defect faster than the original pickup it was installed on by an authorized A.R.E.
The internal skeleton frame will be warranted for three (3) years from your retail date of purchase against failure due to defects in material and workmanship. HD Series has been designed to carry 550 lbs evenly distributed on the HD Series roof rack and 200 lbs evenly distributed in each toolbox.
WARNING: The use of this product may raise your vehicle's center of gravity, especially when loaded. Higher center of gravity is known to increase the chance of vehicle rollover.
Hardware For the original purchaser, lock cylinder, lock housing, fiberglass wings, and center mounted brake lights are warranted for three (3) years from your retail date of purchase against failure due to defects in material and workmanship. Gas props used to assist in opening doors are covered under a five (5) year limited warranty against failure due to loss of pressure.
Regular operation of the props will actually increase the life by lubricating the seals and shafts. Also covered for one year are all seals, brackets, locking hardware, and screens.
WRITTEN WARRANTY IS THE SOLE AND EXCLUSIVE REMEDY PROVIDED FOR ALL A.R.E PRODUCTS. LIMITED WARRANTY, A.R.E., ITS SUCCESSORS OR ASSIGNS, SHALL NOT BE RESPONSIBLE FOR DIRECT DAMAGES AND UNDER NO CIRCUMSTANCES SHALL A.R.E., ITS SUCCESSORS OR ASSIGNS, BE RESPONSIBLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES due to installation, use, misuse, abuse, neglect, or otherwise regarding any product sold, distributed or manufactured by A.R.E.
Exclusions Not covered under this warranty is structural failure due to neglect, alterations, addition of equipment, abuse, accident, off-road driving, use in competitive racing, vibrations from worn or altered truck suspensions or sound equipment, or acts of nature including but not limited to tornados, hurricanes, hail, and earthquakes. Product, it is the owner’s responsibility to immediately bring the issue to the attention of an authorized A.R.E.
Failure to do so could result in additional, more severe problems and constitutes (but is not limited to) neglect, which is not covered. Stress cracks in the fiberglass body that begin from a window, boot, door opening or from the base rail are considered structural or material flaws and are covered under warranty for as long as the A.R.E.
Or its authorized dealer that such stress crack(s) were caused from misuse, abuse, collision or competitive racing. If a stress crack occurs it should be repaired without delay to prevent future failures due to neglect.
Stress cracks in the exterior finish caused by impact are not covered under warranty. A stress crack caused by impact from the inside of the truck cap has the appearance of a “star” on the outside surface.
Consequential damage or loss due to the installation, use, misuse, abuse or neglect of A.R.E. Truck caps are the sole responsibility of the pickup owner and operator.
Paint wear to your truck's bed is normal and is expected with the installation and the use of any truck cap or tonne and is the sole responsibility of the pickup owner. Shall not be held liable for any consequential loss or damages arising from the purchase, installation or use of these products.
The HD MX Series is not available on mini trucks. Mounted directly into our track system, there is no need for additional crossbars.
The basket is made of aluminum and has a black textured powder coat finish. Add lights easily with the 360 degree attachment points.
The Ascend basket is available in three different sizes to best suit your needs, 55" x 42", 55" x 47 “, 55” x 52 “. Roof Basket can be easily installed using our track system in about 45-60 minutes.
By using our track system there is no need for additional crossbars. Truck to provide a mounting system for a roof rack.
These tracks are specifically designed for camper shells or truck caps like yours. To complete the setup you will just need the Landing Pad 1 # Y00221 (for which you will need a quantity of 2), 4 of the Yakima Control Tower part # Y8890027, and a set of round crossbars like the 66 inch # Y00410.
35,570To make sure products work and fit the way they are supposed to. 2,476,5111,125,924 phone calls and 1,350,587 emails to help find the right solution.